SolidWorks Video Tutorial Series

SolidWorks Video Tutorial #12 – The shell feature

SolidWorks Video Tutorial #12 – The shell feature

12 October, 2009

2 Comments
The shell feature is a useful tool that can be applied directly to a solid model. It will allow you to take solid geometry and make it hollow. The Shell feature Video sponsored by SolidProfessor (www.solidprofessor.com).

You may also like

Tags:

2 Comments »

  • Rajesh says:

    Well then you’re either doing tighns right and not following up properly, or you’re just not keeping constant Marine production. If you get see TOO MANY lings , you’re in a good position if you pull back and walled off. Those lings are useless unless he turns them into Banelings to try to break down your wall. The idea of early aggression against Zerg is to KEEP THEM FROM MAKING DRONES WITH THEIR LARVAE! If they made a ling, that’s 1 less drone they have. Too many lings=no drones.

  • yqlphix says:

    kNJSOK , [url=http://djudmylakuzt.com/]djudmylakuzt[/url], [link=http://phtedpqoxwfx.com/]phtedpqoxwfx[/link], http://cusvhfiqaohs.com/

You must be logged in to post a comment.